Filter
Top Products
23
ENGLISH
AVR
Making Connections,
To control more than one source device through the AVR’s IR Remote Out connector,
connect all sources in “daisy chain” fashion, connecting each device’s IR output to the
next device’s IR input, starting with the AVR.
sIf you install a multizone system, connect an IR control device to the Zone 2 IR In
connector for remote-room control of the multizone system, source devices and
volume in the remote zone.
External IR Receiver
Zone 2
Main Room
Zone 2 Speakers
AVR
If a source device is shared with the main listening area, any control commands issued
to that source will also affect the main room.
Connect the Trigger Output
If your system has equipment that can be controlled by a DC trigger signal, connect it to
the AVR’s Trigger Out connector with a mono 1/8-inch (3.5mm) mini-plug interconnect
cable. The AVR will supply a 12V DC (100mA) trigger signal at this connection whenever
it is powered on.
AVR
Device with
Trigger In Connector
Mono 1/8-inch
(3.5mm) Mini-Plug
Interconnect
(not supplied)
Connect to AC Power
Connect the supplied AC power cord to the AVR’s AC Input connector and then to a
working AC power outlet.
AC Power
Outlet
AVR
AC Input
Connector
Power Cord (supplied)