Harman-Kardon AVR65 Home Theater System User Manual


 
Programming the Remote
After following these steps, each time
you press the Power button c, the
remote will send the Power On/Off
command each time the Power
button is pressed.
To remove a macro program, follow steps
1, 2 and 4 above, but do not follow step
three. For example, to erase the macro
just entered, press the Device Control
Selector b and the Mute button d
at the same time until the red light
under the Device Control Selector turns
on. Press the Power button c, and
then press the Sleep button `. The
red light under the Device Control
Selector will blink twice to confirm the
data entry and then turn off.
Volume Punch-Through
The AVR65’s remote may be programmed
to operate the Volume Control z
from either the TV or the AVR to operate in
conjunction with any of the eight devices
controlled by the remote. For example,
since the AVR65 will likely be used as the
sound system for TV viewing, you may
wish to have the AVR’s volume activated
although the remote is set to run the TV.
Either the AVR or TV volume control may
be associated with any of the remote’s
devices. To program the remote for Volume
Punch-Through, follow these steps:
1. Press the Device Control Selector
b for the unit you wish to have asso-
ciated with the volume control and the
Mute button d at the same time
until the red light illuminates under
the Device Control Selector.
2. Press the Volume Up button z.
3. Press either the AVR aor the
TV Device Control Selector
b, depending on which system’s
volume control you wish to have
attached for the punch-through mode.
Note that the red light under the
Device Control Selector will blink
twice and then go out to confirm the
data entry.
Example: To have the AVR’s vol-
ume control be activated even
though the remote is set to control
the TV, first press the TV Device
Control Selector b, and the
Mute button d at the same time.
Next, press the Volume Up button
z, followed by the AVR Device
Control Selector a.
NOTE: Should you wish to return the
remote to the original configuration after
entering a Volume Punch-Through, you
will need to repeat the steps shown above.
However, press the same Device Control
Selector in steps one and three.
Reassigning Device Control
Selectors
Although each of the seven Device
Control Selectors b is normally
assigned to the category of product shown
on the remote, it is possible to reassign
one of these buttons to operate a second
device of another type. For example, if you
have two VCRs, but no satellite receiver,
you may program the “SAT” button to
operate a second VCR. Before following
the normal programming steps for either
Three-Digit entry or Auto Search code
entry, you must first reassign the button
with the following steps:
1. Press the Device Control Selector
b you wish to reassign and the
Mute button d at the same time
until the red light illuminates under
the Device Control Selector.
2. Press the Device Control Selector
b for the function you wish to
program into the reassigned button.
3. Enter the three-digit code for the spe-
cific model you wish the reassigned
button to operate.
4. Press the same Device Control
Selector pressed in Step 1 again to
store the selection.
Example: To use the SAT button to
operate a second VCR, first press the
SAT Device Control Selector
b, and the Mute button d at
the same time until the red light
glows under the SAT button. Press
the VCR button, followed by the
three-digit code for the specific
model you wish to control. Finally,
press the SAT button again.
36
AVR65 120 volt Rev (C) 10/6/98