Filter
Top Products
System Configuration
18
AVR65 120 volt Rev (C) 10/6/98
Speaker Configuration
The first few adjustments tell the AVR65
which type of speakers are in use. This is
important as it adjusts the settings that
determine which speakers receive low-
frequency (bass) information. For each
of these settings use the LARGEsetting
if the speakers for a particular position
are traditional full-range loudspeakers
that are capable of reproducing sounds
below 100Hz. Use the SMALLsetting for
smaller, frequency-limited satellite
speakers that do not reproduce sounds
below 100Hz. Note that when “small”
speakers are used, a subwoofer is
required to reproduce low-frequency
sounds. Remember that the “large” and
“small” descriptions do not refer to the
actual physical size of the speakers, but
their ability to reproduce low-frequency
sounds. If you are in doubt as to which
category describes your speakers, consult
the specifications in the speakers’ owner’s
manual, or ask your dealer.
With the AVR65 turned on, follow these
steps to configure the speakers:
1. Put the AVR65 in the Dolby Pro Logic
mode by pressing the Dolby Pro
Logic Selector Ó on the front
panel or by pressing the Surround
Mode Selector yon the remote,
followed by the
⁄
/
¤
buttons g
until PRO LOGICappears in the
Main Information Display U and
the PRO LOGIC indicator F lights.
2. Press the Speaker button x˘on
the remote or front panel. The words
FRNT SPEAKERwill appear in
the Main Information DisplayU.
If you are using the on-screen display
system, a display will appear indicating
the status of each speaker (Figure 2).
Figure 2
3. Press the Set button i˜.
4. Press the
⁄
/
¤
buttons g on the
remote or the Selector buttons¸
on the front panel until either
LARGEor SMALLappears to
match the type of speakers you have
at the left front and right front posi-
tions, as described by the definitions
shown below.
When SMALLis selected, low-
frequency sounds will be sent to the
subwoofer output only. Note that if
you choose this option, and there is
no subwoofer connected, you will
not hear any low-frequency sounds
from the front channels.
MODE :DOLBY PRO LOGIC
FRONT SP :LARGE SMALL
CENTER SP:LARGE SMALL
NONE
SURR SPK :LARGE SMALL
NONE
SUBWOOFER:OFF ON
MASTER VOLUME:19DB
When LARGEis selected, a full-
range output will be sent to the
front left and right outputs, and
NO low-frequency signals will be
sent to the subwoofer output.
NOTE: If you are using the On-
Screen Display system, the selected
speaker option will appear in high-
lighted video. The selection will
change in response to the steps
outlined on these pages.
5. When you have completed your
selection for the front channel, press
the Set button i˜, and then
press the
⁄
/
¤
buttons g on the
remote or the Selector buttons¸
on the front panel to change the
display to CEN SPEAKER.
6. Press the Set button i˜ again,
and use the
⁄
/
¤
buttons g on
the remote, or the Selector buttons
¸ on the front panel, to select the
option that best describes your system
based on the speaker definitions
shown above.
When CEN SP SMALLis
selected, low-frequency center
channel sounds will be sent to the
subwoofer output only. Note that if
you choose this option and there is
no subwoofer connected, you will
not hear any low-frequency sounds
from the center channel speaker.