Filter
Top Products
NOTICE
-
IMPORTANT SAFETY INFORMATION
RISK OF ELECTRIC SHOCK
00 NOT OPEN
WARNING: TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
A
A
I
0
The lightning flash with arrowhead symbol within
an equilateral triangle is intended to alert the
user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure, that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user of the
presence of important operating and mainte-
nance (servicing) instructions in the literature
accompanying the appliance.
1.
2.
3.
4.
5.
6.
7.
8.
9.
READ INSTRUCTIONS
All the safety and operating instructions of your Hafler equipment should be read before power is applied to the
equipment.
RETAIN OWNERS MANUAL
These safety and operating instructions should be retained for future reference.
HEED WARNINGS
All warnings on the equipment and in the operating instructions are important and should be followed.
FOLLOW INSTRUCTIONS
All operating and use instructions are important and should be followed.
HEAT
The equipment should be kept away from areas of high temperature, such as heater vents, radiators, stoves/ovens,
fireplaces, etc.
VENTILATION
The equipment should be used in an area suitable for proper ventilation. Care should be taken not to impede airflow
in and around the cabinet. Do not mount on a carpeted shelf or in a sealed enclosure. Allow for proper clearance above
the equipment.
WATER AND MOISTURE
The equipment should not be used in or around water, such as a bathtub, sink, or swimming area. Also, the equipment
should not be used in areas prone to flooding, such as a basement.
POWER SOURCES
The equipment should be connected only to a power source of the same voltage and frequency as that listed on the
rear panel above the power cord entry point.
POWER CORD PROTECTION
Power cords should be arranged so that they do not interfere with the movement of objects in the room: people, fan
blades, utility carts, etc. Also, care should be taken that the cord is not pinched or cut, and placed so that it is not in
danger of being pinched or cut, as in under a rug, around a tight corner, etc.
10. POWER CORD GROUNDING
The power supply cord is of a three wire grounded type, designed to reduce the risk of electric shock sustained from
a live cabinet. It is assumed to be of suitable length for most uses of the equipment. The use of extension cords and
power strips is discouraged unless they are of suitable rating to deliver the required total current for safe operation of
all connected equipment. Furthermore, extension cords or power strips must provide the same three wire grounded
connection. It is important that the blades of the equipment’s plug be able to fully insert into the mating receptacle.
Never remove the round grounding pin on the plug in an attempt to mate to a two wire ungrounded receptacle: use
a grounding adaptor with the grounding tab or wire suitably connected to earth ground.
-l-