Filter
Top Products
ZCG3500DSS – GE Monogram Built-In Compactor
Specification Revised 9/03
160005
Dimensions and Specifications (in inches)
22-1/2" min.*
12-1/8"
min.
34"-35"
Adjustable base
2-3/4" to 4-1/4"
*Add 2-1/2" to
depth if outlet
is located directly
behind compactor
12"
20-1/4"
34"
min.
adj. to
35"
max.
R
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
Additional Specifications
A 115 Volt, 60 Hz. power supply is required. An individual properly grounded
branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse
is recommended. Install a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical outlet location is critical for proper cord
storage when compactor is installed.
If the compactor is to be located in or near a corner of base cabinets, allow
2" minimum clearance from the corner to prevent interference with adjacent
door handles.
Note:
If cord is to be plugged in directly behind compactor add 2-1/2" to overall
depth in order to allow proper clearance for the electrical cord.
This Monogram compactor has a
black control panel.
The adjustable base allows the toekick
depth to match surrounding cabinetry.
This compactor is designed as a
built-in appliance only. It may be
located in any convenient space under
a countertop. DO NOT OPERATE FREE-
STANDING because the compactor
will tip over when the drawer is
pulled out.