Filter
Top Products
IMPORTANT:
Go to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
MTP 15HD A Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission
systems.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
Step 2 — Transmitter Inputs
INPUT
AUDIO
MONITOR
• Connect a computer (VGA) video source to the Input connector.
• Connect a VGA monitor to the Monitor connector.
• Plug a 3.5 mm stereo audio plug into the audio jack.
Step 3 — TP Cables Between Units
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
12345678
Insert Twisted
Pair Wires
Pins:
NOTE: If you are using Enhanced Skew-Free™ AV
cable, use the TIA/EIA T568A standard only.
• Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and
the receiver’s Input port.
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.
• For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered Output port
and a daisy-chained receiver’s Input port.
Step 4 — Receiver Outputs
• Connect a VGA monitor to the Output connector.
• Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown
below.
ATTENTION: Connect the sleeves to ground (Gnd).
Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.
1
MONO AUDIO
2
1
MONO AUDIO
2
Unbalanced Output
Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
Step 5 — Receiver DIP Switches
• H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
ON
1 2 3 4 5 6
H SYNC +
V SYNC +
C SYNC
SOG
VIDEO
END UNIT
• Composite Sync, (SOG), and Video switches — Set these switches as shown in the table below to
output the indicated format.
Output Format C Sync SOG Video
RGBHV
RGBS
RGsB
Component*
S-Video*
Composite*
NOTE: * Input video format must match.
• End Unit switch — Set this switches up if either of the following is true:
• The receiver being congured is the only receiver connected to the transmitter.
• The receiver being congured is the last receiver in a daisy-chained system.
OUTPUT
1
MONO AUDIO
2