Escient Digital Music Manager Stereo System User Manual


 
Power to electrical outlet
IR In for IR external
control
Ethernet Network Jack
connects FireBall to your
broadband Ethernet
network.
RS-232 for external
control or touch screen
Analog Out to the
receiver for analog audio
Analog In from external
analog audio source
Optical Out to the
receiver for digital audio
Component Video Out
to the Telly or other
display device
Composite or S-Video
Video Out to the Telly or
other display device
Quick Setup
6640 Intech Blvd.
Indianapolis, Indiana 46278, USA
www.escient.com
Email: support@escient.com
Document Number: M32003-01A2
March 2007
1. UNPACK YOUR NEW FIREBALL™ SEi
• Unpack the FireBall, cables, and accessories (save the box).
• Make note of the serial number (located on the back).
SERIAL NUMBER: _________________________________________
2. CONNECT FIREBALL TO YOUR A/V SYSTEM
• Locate the included composite video and analog audio cables.
• Connect FireBall to any available A/V input on your receiver or Telly.
Note: You may use optional s-video or component video cables and optional digital audio cables
for the best picture and sound quality
Note: The default video output mode is NTSC. Instructions for changing the video mode to PAL
are in the User's Guide.
3. CONNECT FIREBALL TO THE INTERNET
FireBall requires an Internet connection to identify the CDs played and recorded in the front panel
drive, for playing Internet Radio stations, and for general system maintenance.
• Connect the included ethernet cable from
FireBall's ethernet jack to your ethernet
network.
NOTE: You may need to purchase
additional network hardware such as a
"router". Please contact your Escient dealer
for more information.
4. POWER UP!
• Plug FireBall into an AC outlet.
• The Standby LED on the front of the FireBall will begin to flash RED during the power on cycle.
When the LED turns solid RED, the FireBall is ready for use.
• Press the power button on the front panel or on the remote control.
The LED will turn solid BLUE and video will be displayed on the Telly when the unit is on.
Note: You may have to press the "FB1" button on the remote to configure it to control FireBall.
Also be sure the Telly and receiver are turned on and set to the correct FireBall input.
5. QUICK START
Use the remote control and follow the on-screen instructions.
©2007 Escient. All rights reserved. Escient and the Escient logo are
registered trademarks and FireBall and Physital are trademarks of Digital
Networks North America, Inc. All other trademarks are property of their
respective owners. Escient reserves the right to change product hardware,
features and software without notice. Upon any change, materials are
updated as quickly as possible, but may not be reflected in documents
already distributed. Supported hardware is updated continually. If you wish to
interface with hardware that is not listed on this data sheet, please call Escient
at 800.372.4368.