Filter
Top Products
Related tasks
Pairing the 3D Glasses with the Projector
Charging the 3D Glasses
Solutions When a WirelessHD Source Does Not Display Correctly
If a WirelessHD source does not display correctly, try the following solutions:
• Make sure WirelessHD is selected as the image source on the projector.
• Open the WirelessHD reception monitor in the Settings menu and check the strength of the
WirelessHD signal. If the signal is weak, you may need to move the transmitter closer to the projector
or remove any large objects located between the transmitter and the projector.
• Make sure that your projector is connected to the correct WirelessHD device. It can take up to 30
seconds for a signal to sync and appear after connecting.
• You may need to reset the WirelessHD connection. Turn off both the WirelessHD transmitter and the
projector. Start playback on your video device, then turn on the WirelessHD transmitter and the
projector. Wait 10 seconds, then press the Setup button on the bottom of the transmitter.
• Make sure the WirelessHD transmitter is within 32 feet (10 m) of the projector, isn’t obstructed by any
large objects, and is not placed on a metal surface.
• If the green and orange lights on the transmitter are flashing, the unit may be overheating. Make sure
the vents on the back of the transmitter are not blocked and that the room temperature does not
exceed 95 °F (35 °C).
• If you are viewing wireless content, make sure that the WiHD light on the transmitter is on. If it is off,
press the Output button on the remote control or transmitter.
Parent topic: Solving Image or Sound Problems
Related references
Projector Feature Settings - Settings Menu
Related tasks
Viewing WirelessHD Content
Switching WirelessHD Sources
Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions
(PowerLite Home Cinema 3500/3510/3600e):
• Adjust the projector's volume settings.
138