Filter
Top Products
Making Detailed Adjustments 39
■ Block NR (Pro Cinema 9700 UB only)
Note: This setting cannot be used when the Color Mode is set to x.v.Color (see page 28) or
with a signal input through the PC port.
This setting reduces block noise that can appear when projecting MPEG images that have
been compressed at a low bit rate.
■ 2-2 Pull-down (Pro Cinema 9350 only)
Note: This setting can be used only when viewing a 1080p/24Hz signal input through the
Component, HDMI1, or HDMI2 ports (see page 67). This setting cannot be used when the
Color Mode is set to x.v.Color (see page 28) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 2-2 pulldown
detection or 2-3 pulldown detection. Select
On for 2-2 pulldown detection.
■ 4-4 Pull-down (Pro Cinema 9700 UB only)
Note: This setting can be used only when viewing NTSC, M-PAL, or PAL60 signals input
through the Video or S-Video ports, or 480i, 1080i/60Hz, or 1080p/24Hz signals input through
the Component, HDMI1, or HDMI2 ports (see page 67). This setting cannot be used when the
Color Mode is set to x.v.Color (see page 28) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 4-4 pulldown
detection or 2-3 pulldown detection. Select
On for 4-4 pulldown detection.
■ Frame Interpolation (Pro Cinema 9700 UB only)
This setting compares the current and previous frames, then creates a frame between
them to reduce fuzziness and produce clearer moving images. You can select from 3 levels
of frame interpolation.
Note: This setting cannot be changed while the 4-4 Pull-down setting is turned on.
Signal > Advanced > Block NR
Signal > 2-2 Pull-down
Signal > 4-4 Pull-down
Signal > Frame Interpolation