Rev: 10242000
1
FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesirable operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.
SAFETY CERTIFICATION
This compact disc player is made and tested to meet safety standards of the
FCC, requirements and compliance with safety performance of the U.S.
Department of Health and Human Services, and also with FDA Radiation
Performance Standards 21 CFR Subchapter J.
SAFETY PRECAUTIONS
• Do not take the DMP-CD100 apart. The laser beam used in the
DMP-CD100 could harm your eyes.
• Do not insert pins, etc., inside the DMP-CD100. This unit is equipped
with a safety device which automatically turns the laser beam off when
the disc compartment is opened. If a pin or other metal object should get
inside the DMP-CD100, however, this safety device may be deactivated.
• The DMP-CD100 should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.