Filter
Top Products
66
Set up speakers
6
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter Cancel
Subwoofer Measure
RETURN
Enter
Cancel
Measure subwoofer channel
Channel Select
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter Cancel
7
Use ui to select a channel.
Front
Select for setting the front speakers to be used. In this
case, go to step 8.
•“Front” can be set when “Amp Assign” is set to
“Front B”.
Subwoofer
Select for no subwoofers to be used. In this case, go
to step 9.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 10.
•“Surround Back” can be set when “Amp Assign” is
set to “NORMAL”.
Front
Height
Select for no front height speakers to be used. In this
case, go to step 11.
•“Front Height” can be set when “Amp Assign” is set
to “F.Height”.
8
Press o p to select a front speaker.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
4
Use o p to select the
conguration of the connected
speakers.
NORMAL
Select the “NORMAL” setting to perform 7.2-channel
playback using the surround back or front height
speakers.
ZONE2
Select the “ZONE2” setting to assign the unit’s built-
in power amplifier for ZONE2 and output the audio
in stereo.
Bi-AMP
Select the “Bi-AMP” setting to connect the front
speakers via the bi-amp connection.
2CH
When you perform 2-channel playback in the DIRECT
or STEREO mode, select the “2CH” setting to use
the other front speakers for playback.
Front B
Select the “Front B” setting to use the second set of
front speakers for playback.
F.Height
Select the “F.Height” setting to use the front height
speaker for playback.
5
Press RETURN B to exit the “Amp Assign” setting.
Basic version
Advanced version
Information
Advanced version
vSee overleaf