Filter
Top Products
ENGLISH
ENGLISH
61
Advanced Setup – Part 2 Advanced Setup – Part 2
Setting the Subwoofer Setup
Select the method of playback of the subwoofer for playing the low
bass signals.
Press
DD HH
to select “Subwoofer Setup”, then press
ENTER.
Press
FF GG
to set.
LFE:
For any channel(s) that are set to “Large”, low frequencies in that
channel’s corresponding source are directed to that loudspeaker
only. The low frequencies played from the subwoofer are only the
LFE signals and the low frequencies of channels set to “Small”.
LFE+Main:
Low frequencies from speaker channels that have been set to
“Large” are reproduced from those speakers as well as from the
subwoofer(s).
• The subwoofer mode setting is only valid when and “Yes” is set for
the subwoofer in the “Setting the Speaker Configuration”.
• Select the “LFE+Main” mode if you want low frequency signals to
always be played from the subwoofer channel.
• Select the mode achieving a voluminous bass sound when playing
music or movie sources.
Press ENTER.
1
2
3
Setting the Distance
This parameter is for optimizing the timing with which the audio
signals are produced from the speakers and subwoofer according to
the listening position.
Preparations:
Measure the distances between the listening position and the
speakers (L1 to L8 on the diagram at the below).
Press
DD HH
to select “Distance”, then press ENTER.
L1
L2
L3
L4
L5
L6
L7
L8
C FRFL
SW
Listening position
SL SR
SBL SBR
1
1
2
Press
FF GG
to select “Meters” or “Feet”.
2
Press
DD HH
to select the speaker, then press
FF GG
to set.
3
Press ENTER.
4
•Press
DD
to select “Step”, then press
FF GG
to change the amount of
variation if so desired.
• The distance changes in units of 1 foot (0.1 meters) or 0.1 foot (0.01
meters) each time the button is pressed. Select the value closest to
the measured distance.
• Please note that the difference of distance for every speaker
should be 20 ft (6.0 m) or less. If you set an invalid distance, a
CAUTION notice, such as screen right will appear. In such cases,
move the appropriate speaker to the position of the displayed
value.
1
2
3
..... L1
..... L2
..... L3
..... L4
..... L5
..... L6
..... L7
..... L8