Filter
Top Products
Advanced Setup – Part 1 Advanced Setup – Part 1
59
ENGLISH
ENGLISH
Setting the Setup Lock
This sets whether or not to lock the system setup settings so that
they cannot be changed.
Press
DD HH
to select “Setup Lock”, then press ENTER.
Press
FF
to select “ON”, then press ENTER.
• When the setup lock function is activated, the settings listed below
cannot be changed, and “SETUP LOCKED!” is displayed when
related buttons are operated.
• System setup settings
• Surround parameter settings
•Tone control settings
• Channel level settings (including test tones)
• Room EQ settings
•To unlock, press SYSTEM SETUP again and display the “Setup Lock”
screen, then select “OFF” and press ENTER.
1
2
1
2
Setting the Trigger Out
Press
DD HH
to select “Trigger Out”, then press ENTER.
Press
FF GG
to select “MAIN” or “ZONE2”.
The power supplied from the trigger out jack turns on and off
when the power for the set zone is turned on and off.
Press
DD HH
to select the trigger out jacks, then press
ENTER.
Use the DC 12 V output of the AVR-2307CI’s two trigger out jacks in
association with the various input sources and surround modes.
If “ZONE = MAIN” is selected, settings can be made for the individual
surround modes.
1
2
3
Press
DD HH
to select the input source, then press
FF GG
to set.
ON, OFF:
When that input source is selected, the power supplied from the
trigger out jack turns on (or off).
4
Press ENTER.
When “MAIN” was selected at step 3:
Press
DD HH
to select the surround mode, then press
FF
GG
to set.
ON:
If “ON” is selected when an input source set to “ON” is selected,
the power supplied from the trigger out jack turns on.
OFF:
If “OFF” is selected when an input source set to “ON” is selected,
the power supplied from the trigger out jack turns off.
5
6
1
2
3
4
5