Filter
Top Products
Basic Operation Basic Operation
28
ENGLISH
ENGLISH
• Select “DEFAULT Y/N” and press
FF
to reset all the settings.
Press
DD HH
to select the item, then press
FF GG
to set.
The surround parameter switches in the following order each
time SURROUND PARAMETER is pressed for the different surround
modes.
• When the MONO MOVIE, ROCK ARENA, JAZZ CLUB and
VIDEO GAME mode:
Press ENTER or SURROUND PARAMETER.
Selecting the DSP surround simulation
Press SURROUND PARAMETER.
Press [DSP SIMULATION].
5CH/7CH STEREO
MONO MOVIE
JAZZ CLUB
ROCK ARENA
MATRIX
VIDEO GAME
VIRTUAL
The 5CH/7CH STEREO mode can be selected directly by pressing
[5CH/7CH STEREO].
1
2
3
4
ROOM SIZE:
Adjust the imaginary size of the recreated sound field space. (Does
not express size of room in which played.)
There are five parameters: “small”, “med.s”, “medium”, “med.l”
and “large”.
SB CH OUT
• ON:
Surround back channel played.
• OFF:
Surround back channel not played.
EFFECT LEVEL:
Adjust the strength of the surround effect.
DELAY TIME: (MATRIX mode only)
Adjust the delay time between “0 ms” and “110 ms”.
ROOM SIZE
EFFECT LEVEL
DEFAULT
SURROUND BACK
TONE DEFEAT
TONE DEFEAT
DEFAULT
• When the VIRTUAL mode:
If you do want the bass and treble to be adjusted, turn off the
tone defeat mode.
DELAY
DEFAULT
SURROUND BACK
TONE DEFEAT
• When the MATRIX mode:
¢To operate the surround mode and the surround
parameters from the remote control unit
¢Operating the surround mode and the surround
parameters from the main unit’s panel
Use
<
SELECT
/ENTER
>
to select the surround mode.
DIRECT STEREO
MONO MOVIE
DTS NEO:6
5CH/7CH STEREO
MATRIXVIRTUAL SURROUND
DOLBY PRO LOGIC
II
x
ROCK ARENA
JAZZ CLUB
VIDEO GAME
1
To select the surround mode while adjusting the surround parameters,
tone defeat or tone control, press
<
SURROUND MODE
>
, then operate
the selector.
Perform steps 2 to 4 under “Selecting the DSPsurround
simulation”.
2
About the button names in this explanation
<>
: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
[CH SELECT],
ENTER
D H F G
D H F G
SURROUND
PARAMETER
[DSP SIMULATION]
ENTER
[5CH/7CH STEREO]
<SURROUND MODE>,
SURROUND PARAMETER
<POWER> D H
F G,
SELECT/ENTER
<PRESET •><ON/STANDBY>