Filter
Top Products
WWW.ONEFORALL.COM 25
Problem & Solution
Trouble-Shooting
Problem:
Your brand is not listed in the
code section?
The KAMELEON 6 does not
operate your device(s)?
The KAMELEON 6 is not
performing commands
properly?
Problems changing channels?
Video / PVR / DVD / CD / AUD
not recording?
The KAMELEON 6 does not
respond after pressing a key?
Your original remote had a
“20” key?
Upon each keypress, the top
segment of the IR indicator
will blink 5 times.
You are not able to enter
programming mode?
Solution:
Try the search method on page 11.
A) Try all the codes listed for your brand.
B) Try the search method on page 11.
You may be using the wrong code. Try
repeating the Direct Set-Up using another
code listed under your brand or start the
search method over again to locate the
proper code.
Enter the program number exactly as you
would on your original remote.
As a safety feature on your KAMELEON 6,
you must press the Record key twice.
Make sure you are using new batteries and
are aiming the KAMELEON 6 at your
device.
You can find this function on the AV key.
Replace batteries with 2 fresh, new
“AA/LR6” alkaline batteries.
Replace batteries with 2 fresh, new
“AA/LR6” alkaline batteries.
To conserve battery life, your Kameleon remote is fitted with a light sensor,
which adjusts the brightness of the display to suit its environment. For example,
it is not necessary to have the display at full brightness in a darkened room,
so the remote dims the display somewhat.
If you do not require this function, it can be disabled. To do this:
1. Press and hold down the Magic key (for about 3 seconds) until the rab-
bit comes out of the hat (the screen will change to the setup screen).
2. Press OTHER.
3. Press 9 9 9.
The animated IR Indicator will blink four times and the light sensor is now
disabled.
To re-enable it, repeat the above steps and the IR Indicator will blink twice.
Kameleon_6_nieuw_2004_11x23 Eur 23-08-2004 11:13 Pagina 25