Crosley KAMELEON CD Player User Manual


 
WWW.ONEFORALL.COM 13
The KAMELEON 6 comes with a complete library of pre-programmed codes.
After you have set up the KAMELEON 6 for your device, you may find that there
are one or more keys that you had on the original remote control, which do not
have a place on the KAMELEON 6 keypad.
The KAMELEON 6 offers a special Learning feature that allows you to copy
almost any function from your original remote control onto the keypad of the
KAMELEON 6.
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your KAMELEON 6, nor your original remote
control is pointing at your device.
Learning (direct)
Example: To copy the “mono/stereo” function from your original TV
remote control onto the ”A”-key of your KAMELEON 6.
1. Place the KAMELEON 6 and your original remote control on a flat
surface. Make sure the ends which you normally point at your device
are facing each other. Point the original remote to the front of the
KAMELEON 6 (see picture below). Keep the remotes at a
distance of 2 to 5 cm (0.8 to 2 inches).
2. Press and hold down the MAGIC key (for about
3 seconds) until the rabbit comes out of the hat
(the screen will change to the setup screen).
3. Press IR LEARN.
4. Press the device key (Example: TV key) on the KAMELEON 6
remote to select the mode to which you want to copy the
learned function.
5. Press the key (Example: ”A” key) on the KAMELEON 6 remote
where you want to place the learned function. The IR Indicator
will show “incoming IR” three times and then the display will
switch off.
6. Press and hold the key that you want to copy (Example:
mono/stereo) on your original remote control. The display
switches back on and you will see two blinks to indicate suc-
cessful learning operation.
7. If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning. If you
want to copy another function in a different mode, simply continue with
step 4 followed by steps 5 and 6.
8. To exit the learning mode and return to the user screen, press
the ESC key twice.
Learning Feature
(How to copy functions from your original working remote onto the
KAMELEON 6)
(x2)
Kameleon_6_nieuw_2004_11x23 Eur 23-08-2004 11:13 Pagina 13