Open as PDF
Destiny 2 CD Player
Congratulations on your purchase of Creek’s Destiny 2 CD Player. Please read this manually thoroughly. It will explain in detail the features and operation of your
Destiny 2 CD Player and help to ensure a trouble free installation. Unpack the player carefully. It is recommended that you save the carton and packing material for
future use, should you need to move your player or return it for service. Your Destiny 2 CD Player is designed to work in a horizontal position. It is important to allow
at least 5 cm of space behind the unit for adequate ventilation. To avoid damage, never place it near radiators, in front of heating vents, in direct sunlight or in an
excessively humid or dusty location.
This CD player is designed to operate on 220-240 Volts 50 Hz AC or 110-120 Volts 60 Hz AC. Normally the equipment is supplied with a mains lead with a fitted 3 pin
plug suitable for the country in which it is to be used. If the plug needs to be changed, please note that the wires in the mains lead are coloured in accordance with
the following code:
Blue - Neutral Brown - Live Green/Yellow - Earth
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in residential installations. This equipment generates and can radiate radio frequency energy and if
not installed and used in accordance with the instructions may cause interference to radio communications. However there is no guarantee that interference will
not occur in some instances. If this product causes interference to radio or television reception, which can be determined by turning the equipment off and on, try
to correct this by one or more of the following measures:
Relocate or re-orient the receiving antenna
Increase the separation between the equipment and the radio or TV receiver
Connect the equipment into a mains outlet on a circuit different from that to which the receiver is connected
Consult your dealer or an experienced radio/TV technician
TO ACHIEVE MAXIMUM PERFORMANCE FROM YOUR CD PLAYER
Install the equipment in a location which is relatively free of moisture and dust, and is well ventilated.
The equipment may not be able to perform at its best in an extremely cold or hot environment. Do not attempt to use below 41°F/5°C or above
Always handle discs with clean hands.
Avoid using scratched discs.
Do not attempt to clean the CD player or discs with chemical solvents, as this may cause irreparable damage. Use a clean, dry cloth, or specially
designed cleaning materials for discs.
If the CD player malfunctions, do not open the unit and attempt to repair it yourself. This is a highly technical product and requires specialist service -
return it to your dealer.
Use batteries (2 x AAA) of the same type in the remote control handset. The use of odd or different type cells will affect its performance. Batteries are
Keep this manual in a safe place for reference.
Do not put anything except a compact disc into the tray. Foreign objects can damage the mechanism.
DVD’s will not play.
Do not force the tray by hand during the opening and closing operations.
To avoid dirt and dust entering the mechanism, keep the disc tray closed when the CD player is not in use.
Never load two discs into the tray.
The Destiny 2 CD player has been designed to play compact discs bearing the illustrated logo. DVD discs cannot be played. Always place the CD in
the disc tray with the label facing up. CD’s can only be played on one side. To remove a CD from its storage case, press down on the centre of the
case and lift the disc out, holding it carefully by the edges. Fingerprints and dust should be carefully wiped off the CD’s signal surface (glossy side)
with a soft, dry cloth. Wipe the disc in a straight motion from the inside out. Small dust particles and stains will have absolutely no effect on
reproduction quality. Never use chemicals such as record sprays, antistatic sprays or fluids, benzine or thinners to clean a compact disc as such
chemicals would irreparably damage the surface.
Store the discs in their cases when not in use to avoid serious scratches which could cause the laser pickup to skip. Do not expose the discs to direct sunlight, high
humidity, or high temperatures for extended periods. Long exposure to high temperatures can warp the discs. Do not stick paper or write anything with a ballpoint
pen on the disc surface.