Creative 1212M CD Player User Manual


 
4 - The PatchMix DSP Mixer
The Session
28 Creative Professional
The Session
The current state of the PatchMix DSP mixer (fader settings, effects routings…every-
thing!) can be saved as a Session. Whenever you create or modify a mixer setup, all you
have to do is Save it to be able to recall it at a later time.
Before you begin using PatchMix DSP, you need to set it up to be compatible with the
other software applications you may be running. The most important consideration is
your system sample rate. PatchMix DSP and any applications or other digital gear you
are using must be set to the same sample rate. PatchMix DSP can run at 44.1k, 48k,
88.2k, 96k, 176.4k or 192k, but its complete set of features are only available at
44.1kHz or 48kHz. See Chapter 6 - Using High Sample Rates for complete details.
Once the sample rate is set, you can only easily switch between 44.1k and 48k. You cannot
switch between 44/48k and the higher rates of 88k/96k/176k/192k. This is because the
number of mixer inputs and outputs changes significantly at these high sample rates. In
the case of such drastic sample rate changes, you must start a new session.
Important: When
using any form of digital
input, you MUST
synchronize the Digital
Audio System to the
external digital device
(S/PDIF/ADAT) or
synchronize all devices
using Word Clock.
You can also set up an external sync source, thereby obtaining the sample rate from
some other device or application. External sync can be obtained from the ADAT input,
S/PDIF input or the Sync Daughter Card word clock. If the session is set at 44.1kHz or
48kHz and the external source is coming in at 96kHz (for example), the Sync Indicator
will be extinguished (off), but PatchMix will attempt to receive the external data. The
two units are NOT sample locked however, and you should correct this condition to
avoid intermittent clicks in the audio. Always check for the presence of the LOCKED
indicator whenever you are using a digital interface.
PatchMix DSP comes with several session templates to choose from so when you create
a new session you can either create a “blank” session based around a designated sample
rate, or select from a list of template starting points.
In a PatchMix DSP session the number of strips in the mixer is dynamically config-
urable. This allows you to create only those strips you need up to a maximum number
determined by available DSP resources and available inputs.
New Session
You create a new session by clicking the “New Session” button in the PatchMix DSP
main Toolbar. The following dialog box appears.
Select a Template or new
Session at the desired
sample rate
Session Description
Add your own comment
or note about the Session
Check this if you want to
edit the New Session.