Filter
Top Products
16 VXZ766
English
8. OPERATIONS
Basic Operations
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 5 (unfold).
!
CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting. If you switch the power off with the
volume up, when you switch the power back
on, the sudden loud volume may hurt your
hearing and damage the unit.
System check and speaker setting
During the initial power up of this unit, it will go
through a system check procedure.
This procedure verifies any devices connected
through CeNET. Any additional CeNET devices
plugged into the unit after the initial power up
will initiate the system check procedure.
1. When the power is turned on,
“SYSTEM”
appears in the display if the wire connections
were modified.
The system check starts automatically within
the unit.
2. When the system check is complete,
“SP-SET” appears in the display. Perform the
speaker setting.
3. Turn the [ROTARY] knob to select the
speaker system.
• The factory default setting is “2ch”. (Adjustment
2ch/5.1ch)
• To enjoy 5.1ch surround sound more effectively,
we recommend equipment of the center speaker
and the sub-woofer.
4. Press the [ ] button.
• The setting is complete and the display switches
to the radio mode.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car’s
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [SRC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [SRC] button to change the
operation source mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio mode ➜ DVD mode ➜ (CD
changer mode) ➜ (TV mode) ➜ AUX
mode ➜ Radio mode...
• External equipment not connected with CeNET is
not displayed.
Adjusting the volume
1. Turn the [ROTARY] knob to adjust the
volume.
• The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
1. Each time you press the [DISP] button, the
display switches in the following order:
Main display ➜ Clock display ➜
Main display...
• Once selected, the preferred display becomes the
display default. When a function adjustment such
as volume is made, the screen will momentarily
switch to that function’s display, then revert back to
the preferred display several seconds after the
adjustment.
1. Press and hold the [DISP] button for 4
seconds or longer to turn off the display.
2. To turn on the display, press the [DISP]
button again.
VXZ766.book Page 16 Monday, January 16, 2006 6:43 PM