Filter
Top Products
Basic Operation
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
1) Press the POWER button 4.
*
To turn the power off, press the POWER button for
at least 1 second.
2) Press the FNC button 4 to select the opera-
tion mode. The mode switches as follows
each time the FUNC button is pressed:
Radio ➜ Tape ➜ CD changer ➜ Radio
*
If a component is not connected, that operation
mode cannot be selected.
*
“NO CASS” appears when no tape is loaded in
the source unit, and “NO DISC” appears when no
disc is loaded in the CD changer.
3) Turning the Rotary knob 2 clockwise
increases the volume; turning it counterclock-
wise decreases the volume.
*
The volume level is from 0 (minimum) to 33 (max-
imum).
Audio Mode Adjustments
Press the A-M button 3 to select the adjustment
mode. The mode switches as follows each time
the A-M button is pressed:
BASS ➜ TREB ➜ BAL ➜ FAD ➜ Previous
mode
Adjusting the Bass
1) Press A-M button 3 and select “BASS”.
2) Turning the Rotary knob
2 clockwise empha-
sizes the bass; turning it counterclockwise
attenuates the bass.
*
The factory default setting is “0”. (Adjustment
range: –6 to +6)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
Adjusting the Treble
1) Press A-M button 3 and select “TREB”.
2) Turning the Rotary knob
2 clockwise empha-
sizes the treble; turning it counterclockwise
attenuates the treble.
*
The factory default setting is “0”. (Adjustment
range: –6 to +6)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
Adjusting the Balance
1) Press A-M button 3 and select “BAL”.
2) Turning the Rotary knob
2 clockwise empha-
sizes the sound from the right speaker; turn-
ing it counterclockwise emphasizes the sound
from the left speaker.
*
The factory default setting is “0”. (Adjustment
range: L9 to R9)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
Adjusting the Fader
1) Press A-M button 3 and select “FAD”.
2) Turning the Rotary knob
2 clockwise empha-
sizes the sound from the front speakers; turn-
ing it counterclockwise emphasizes the sound
from the rear speakers.
*
The factory default setting is “0”. (Adjustment
range: F9 to R9)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
*
The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button @, the
tone effect changes in the following order.
“Z-ENHANCER 1” ➜ “Z-ENHANCER 2” ➜
“Z-ENHANCER 3” ➜ “Z-EHCR OFF” ➜
“Z-ENHANCER 1”...
8 AX410
English
7. OPERATION
CAUTION
Note:
•
Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).