Filter
Top Products
Switching to the Other Side of the
Tape
Press the PROG button #. Playback is switched
to the other side of the cassette tape.
FF Scan Function (Intro Music Scan)
When the SCN button 0 is pressed, “SCN”
appears on the display, and the first 10 seconds
of all the tracks on the cassette tape are played.
Press the SCN button again to stop scanning.
Repeat Function (Repeat Play)
When the RPT button 9 is pressed, “RPT”
appears on the display and the current track is
played repeatedly. Press the RPT button again
to cancel the repeat mode.
Blank Skip Function
Use this function to automatically skip to the
beginning of the next recorded section when
there is a blank section of 12 seconds or more
on the tape.
When the BLS button 9 is pressed for 1 second
or longer, the blank skip mode is set and “BLS”
appears on the display. Press the BLS button 9
again for 1 second or longer to cancel the blank
skip mode.
Notes:
The APC, scan, repeat and blank skip functions will not
work with the following types of tapes:
•
Tapes on which the recording level is low
•
Tapes on which there is less than 4 seconds of blank
space between selections
•
Tapes on which there are long pauses in the middle
of selections
•
Tapes on which there is much noise between selec-
tions
Radio Operation
FM Reception
For enhanced FM performance the
®
tuner includes signal actuated stereo control and
Multipath noise reduction circuits.
Listening to the Radio
1) Press the FNC button 4 and select the radio
mode. The radio turns on.
2) To tune in a preset station, first press the
BND button
# and select FM1, FM2, FM3 or
AM.
The band changes as follows each time the
BND button is pressed:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1
3) Use the Preset buttons
! to select the
desired station.
Mute
Use this function to turn off the sound immedi-
ately.
Press the MUTE button %. The sound turns off
and “MUTE” appears on the display. Press the
MUTE button again to cancel the mute mode.
Seek Tuning
1) Press the BND button # and select the
desired band.
2) Press the SRCH Left or Right button
$. Seek
tuning automatically stops when a station is
found.
Manual Tuning
1) Press the BND button # and select the
desired band.
2) Press the BND button again for more than 1
second. “
MANU” lights in the display and the
manual tuning mode is set.
3) Use the SRCH Left and Right buttons
$ to
tune in the desired frequency.
10 AX410
English