Clarion ADZ625 Cassette Player User Manual


 
20 ADZ625
3. Turn the [VOLUME] knob either clockwise or
counterclockwise to set the sensitivity of the
spectrum analyzer.
You can choose one of LOW, MID or
HIGH for the sensitivity of the spectrum ana-
lyzer.
4. Press the [T] button to return to the previous
mode.
Setting the speed of the spectrum
analyzer display
The factory default setting is HIGH.
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [ ] button or the [ ] button to
select ANA SPD.
3. Turn the [VOLUME] knob either clockwise or
counterclockwise to set the speed of the spec-
trum analyzer display.
You can choose one of LOW, MID or
HIGH for the speed of the spectrum ana-
lyzer display.
4. Press the [T] button to return to the previous
mode.
Entering titles
Titles up to 10 characters long can be stored in
memory and displayed for radio or TV stations
and CDs. The numbers of titles that can be en-
tered for each mode are as follows.
Mode Number of titles
Radio mode 30 titles
CD mode 100 titles
TV mode 15 titles
CD changer mode Number of titles
CDC655z connected 60 titles
CDC655Tz connected 100 titles
CDC1255z connected 50 titles
1. Press the [FNC] button to select the mode you
want to enter a title. (radio, CD, CD changer or
TV)
Titles cannot be entered for MDs with this unit.
2. Select and play a CD or a CD in the CD changer,
or tune to an appropriate TV or radio station.
3. Press the [DISP] button and display the title.
4. Press the [T] button. TITL appears in the dis-
play and the cursor position flashes.
Operation Common to Each Mode
Setting the clock
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [ ] button or the [ ] button to
select CLOCK__E.
3. Press the [ ] button.
4. Press the [ ] button or the [ ] button to
select the hour or the minute.
5. Turn the [VOLUME] knob either clockwise or
counterclockwise to set the correct time.
The clock is displayed in 12-hour format.
6.
Press the [ ] button to store the time into
memory.
7.
Press
the [T] button
to return to the previous
mode.
Note:
You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the cars
battery or take out this unit, the clock is reset. While
setting the clock, if another button or operation is
selected, the clock set mode is canceled.
Switching the spectrum analyzer
display patterns
You can select one out of 8 patterns or set it to
off.
The factory default setting is PATTERN 1.
Each time you press the [SPE/ANA] button, the
spectrum analyzer display pattern changes in the
following order:
PATTERN 1 PATTERN 2 PATTERN 3
PATTERN 4 PATTERN 5 PATTERN 6
PATTERN 7 SCAN OFF PATTERN 1...
Note:
The spectrum analyzer display is unavailable during
these operations below;
Seek tuning and auto store in radio mode.
Mute or pause.
When NO DISC or an error message appears in
the display.
Setting the sensitivity of the
spectrum analyzer
The factory default setting is MID.
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [ ] button or the [ ] button to
select ANA SENS.