Filter
Top Products
6
Installation of Turntable Platter
Method of Using Slip Mat
Installation of Cartridge
Never connect the AC power plug before assembly has
been completed.
1
By placing the turntable platter on the center spindle, the platter
adjusts to match the spindle by itself.
2
Place the slip mat on the platter.
3
Extra care should be taken to avoid damaging magnet by
dropping it.
1
Place slip mat on the turntable platter, and place the record on
the slip mat. It is possible to stop and return the record by hand
while the turntable revolving.
Red (R+) Right Channel+ Green (R-) Right Channel -
White (L-) Left Channel+ Blue (L - ) L e f t Channel -
1
In accordance with the instructions of the cartridge, install a
cartridge properly.
2
Connect the lead wires to the cartridge terminals. The terminals
of most cartridges are color corded. Connect each lead wire to
the terminal of the same color.
1
Place the balance weight a n d weight ring on the rear shaft of
the tone-arm winding the balance weight clockwise.
N O T E
In case the cartridge weight is less than 8g, it is
necessary to fix the attached shell weight on the
cartridge.
N O T E
ASSEMBLY AND SET-UP
Installation of Balance Weight
Surface of slip mat (printed): Disk side
Inside of slip mat : Slip side