CK Electric Part PDX-8000 Turntable User Manual


 
4
A.S.T.S(Anti Skipping Tone-arm System)
A.S.T.S(Anti Skipping Tone-arm System) has been developed with years of
experience and a number of trials, searching for the innovative tone-arm for
professional DJ's.This system breaks all of the historic common sense,
achieving its non skipping performance in hard scratching. A.S.T.S consists
of two inventions, short/straight arm and TH (Tracing Hold) balance system.
TH balance system gives horizontal movement in addition to vertical. This movement gives much more stable
balance (ve rtical direction) to the needle. The combination of short / straight arm and TH balance system
gives the best stability to the needle, which enables anti-skipping in hard scratching.
The brass arm with aluminum cover is used for A.S. T.S . This combination results in the best pick up
s e n s i t ivity as well as the best resistance to how l i n g. This new tone-arm allowed A.S. T.S to increase the
resistance against the howling by over 50% compared to the normal aluminum arm.
REMOTE CONTROL
It is possible to control two turntables remotely.
1
Prepare for 3.5mm monaural phone plug cable Turn on Sync ON/OFF SW.
2
Connect REMOTE OUT JACK at the rear panel with another PDX-8000 REMOTE IN JACK at the rear panel by using
the cable.
3
The player connected at the REMOTE OUT JACK is MASTER of the PDX-8000. The player connected at the REMOTE
IN JACK is the Slave of the PDX-8000.
4
Pushing START/ STOP SWITCH of the master PDX-8000 will make the connection between master PDX-8000 and
slave PDX-8000. Then slave PDX-8000 acts the same as master PDX-8000 without touching slave PDX-8000.
Connecting the REMOTE IN JACK of third PDX-8000 with REMOTE OUT JACK of slave PDX-8000, third PDX-8000
will also act the same as master PDX-8000 It is possible to connect a fourth PDX-8000, to be controlled the same as
master PDX-8000 by REMOTE CONTROL.