Filter
Top Products
2
Model IW601
Installation:
h
h
h
h
h
Use the included template to mark and cut a hole in the
drywall.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, all speakers in the system must be
wired alike. Connect red wires to red terminals on
speaker and to red or plus terminals on amplifier.
Install the IW601 in the hole. Tighten the mounting
screws. The mounting dog ears will rotate outward and
grip the drywall.
Aim tweeter
Mounting screws (6)
3
Specifications:
Frequency range:
Sensitivity:
Power Handling:
Drivers:
Impedance:
Finish:
Dimensions:
Hole Size:
45Hz - 20kHz ± 3dB
90dB (1W/1m)
150-Watts Peak
1- 1” soft dome tweeter
1- 6.5” polypropylene woofer
8 ohms
ABS plastic
12.0”H x 8.75”W x 3.44”D*
*from surface of wall board
10.625”H x 7.25”W
Specifications subject to change without notice.
Features:
High power handling capacity
2nd order crossover 12dB per octave with poly switch for
tweeter protection.
6.5” polypropylene woofer with butyl rubber surround
1” pivoting soft dome tweeter
Gold speaker terminals
Small perforated designer grille
Mounting template and paint shield included (rough-in
bracket sold separately model: IW65B)
Recommended power: 20W to 100W