Filter
Top Products
SPECIFICATIONS
Operating the CD-306/200 CD Transport/Processor is a simple procedure, since each unit is
designed for long term stability in virtually any home operating situation. However, if the unit is
operated outside the parameters outlined in this owner’s manual, damage may result. Please
read this manual carefully before putting your new Cary Audio Design CD-306/200 in operation.
The following definitions are applicable to this manual. Please follow these definitions
carefully.
WARNING
HAZARD PRESENTS PERSONAL INJURY OR DEATH
Caution
EQUIPMENT DAMAGE MAY OCCUR BUT NOT PERSONAL INJURY
Note
Proper performance of the CD PLAYER cannot be ensured
if disregarded
1.1 Specifications
The following section describes the CD-306/200 CD Transport/Processor basic specifications.
Specifications are subject to change without notice or obligation.
CD Mechanism Philips CDM12
Master Clock Jitter Below measurable levels
Digital Filter Pacific Microsonics PMD-200 with HDCD decoding
Digital / Analog Converters (8) Burr Brown PCM1704u
Analog Filter 3
rd
Order Bessel
Analog Outputs Balanced XLR , Single – Ended RCA
Digital Outputs AES/EBU, Coaxial, Toslink
Digital Input AES/EBU, Coaxial, Toslink
Digital Input Sample Rate 32kHz, 44.1kHz, 48kHz, 88.2kHz and 96kHz
Accepts 16, 20 or 24 bits
Frequency Range …………………………………… 2 Hz - 80 kHz (192kHz)
Amplitude Linearity………………………………… 0.1 dB (20Hz - 20kHz)
Phase Linearity……………………………………… 3°(20 Hz - 20 kHz)
Dynamic Range………………………………………120dB (1kHz)
Signal-to-Noise Ratio………………………………...122dB (1kHz)
Channel Separation…………………………………. 109dB (1kHz)
Total Harmonic Distortion……………………………0.0008% (1kHz)
Audio Output Level…………………………………..Single-Ended 3.0Vrms
Balanced XLR 6.0Vrms
Power Input Reconfigured at factory
100-120/200-240 Vac, 50-60 Hz
Power Consumption 35 Watts
P.2