Open as PDF
IMPORTANT SAFETY INSTRUCTIONS
15. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or those having the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock or other hazards.
16. SAFETY CHECK: Upon completion of any service or repairs to the unit, ask the service technician to perform
safety checks to ensure the unit is in proper operating condition.
17. IMPORTANT SAFETY NOTE:
Before connecting a new product such as the CD 303T to your audio or home theater system, turn off all other
equipment (preferably unplugging them from the AC power source). Many audio components feature automatic
turn-on circuits that may activate during an installation, potentially causing damage to electronic components
and/or speakers. This type of damage is not covered by product warranties, and Cary Audio specifically disclaims
responsibility for any such damage.
Power Cord: The removable power cord provided with your player was specifically designed
for use with this product, but other AC cords may be used. Consult your dealer for advice on AC
power cords and high quality wire in your system.
AC Fuse: The fuse is located inside the chassis and is not user serviceable. If the unit does not power up,
contact an authorized service representative
Wiring: Cables running inside walls should have the appropriate markings to indicate compliance and listing by
the UL, CSA or other standards required by the UL, CSA, NEC or your local building code. Questions about
cables inside of walls should be referred to a qualified custom installer, a licensed electrician, or low-voltage
18. RECORDING COPYRIGHT: Recording of copyrighted material for other than personal use is illegal without
permission of the copyright holder.
19. NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV system installer's attention to
article 820-40 of the NEC, ANSI/NFPA 70, which provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry
20. FCC INFORMATION FOR USER:
CAUTION: Any changes or modifications not expressly approved by Cary
Audio Design could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions it may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from where the receiver is
21. OUTDOOR ANTENNA
ANTENNA AND CABLE CONNECTION:
If an outside antenna or cable system is connected to the equipment,
be sure the antenna or cable system is grounded in order to provide
protection against built-up static charges and voltage surges. Article
810 of the National Electrical Code, ANSI/NFPA 70 (in Canada, Part 1
of the Canadian Electrical Code) provides information regarding proper
grounding of the mast and supporting structure, grounding of the
lead-in wire to an antenna discharge unit, size of grounding
conductors, location of antenna discharge unit, connection to
grounding electrodes and requirements for the grounding electrode.
Outside antenna system should be located well away from power lines,
electric light or power circuits and where it will never come into
contact with these power sources if it should happen to fall. When
installing an outside antenna, extreme care should be taken to avoid
touching power lines, circuits or other power sources as this could be
fatal. Because of the hazards involved, antenna installation should be
left to a professional.