Filter
Top Products
Performer Plus™ Owner’s Manual
2
Initial Setup
Visit us online at califone.com
AC Line Operation
1. The power cord is located at the rear of the unit. Release the cord retainer tab and uncoil the cord.
2. Plug the cord into a standard 120 volt 50-60 Hz AC outlet. Be sure the plug blades are fully inserted.
THE UNIT IS ON WHEN PLUGGED IN.
Battery Operation
1. The battery compartment is located at the rear of the unit. Push the lever at the center of the door toward
the rear of the unit, then lift the door free.
2. Eight “D” size batteries are required. Refer to the orientation diagram shown inside the battery compartment
when installing. Place the batteries on top of the nylon ribbon to help “pop” out the old batteries when you
need to replace them.
3. Replace the battery cover.
IMPORTANT:
Remove all batteries from your cassette unit if it will not be used for an extended period of time.
DO NOT USE RECHARGEABLE BATTERIES AND DO NOT LEAVE DISCHARGED BATTERIES IN THE BATTERY COMPARTMENT.
NOTE:
Califone cassette player/recorders are designed for use only with 60 minute Type 1 Normal Bias recording tape.