Filter
Top Products
Setting the alarms
Note: Youcan set alarms with the Wave Radio/CD on or off
Function
To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm
setup mode. ALARM 1 flashes for 10 seconds.
To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm
sound (tone o_)),radio, or CD), for Alarm 1. Press Alarm Setup again until ALARM 2 is flashing.
While it flashes for 10 seconds, begin to set Alarm 2.
To set the alarm time - While the selected alarm is flashing, press the Time _ or _ to set the
alarm time. The selected alarm flashes for 10 seconds.
To set the alarm source - While the selected alarm is flashing, press FM, AM, or CD to select
and display that source. The tone ,>))is no longer selected.
• To reset to tone, press the source currently selected (FM, AM, or CD), which deselects it.
When no source is displayed, the alarm is set to tone ._)).
• Setting FM or AM alarm, the station last used for this alarm is shown. Or, use Presets or
Track/Tune <_ or _> to select a station.
Setting CD alarm, track 1 is shown. Or, use Track/Tune <:_or # to select a specific track or time
location for the alarm. Press CD Mode _ to select RANDOM or TRACK REPEAT. The CD
plays, repeating as needed, until the alarm shuts off.
To set radio or CD followed by tone ._)),select radio or CD alarm, then press o_))CD Stop m.
AUX is not available as an alarm source.
To set the alarm volume - While the selected alarm is flashing, press Volume A or T to set
the alarm volume, from 10 to 99. The selected alarm flashes for 10 seconds.
?:rack/Tune
To test the alarm volume - While the selected alarm is flashing, hold down Alarm Setup and
press Volume A or V to hear the volume setting, as demonstrated by the tone .7))alarm only.
To adjust snooze time - The system is set for a standard 10-minute snooze time (the number
of minutes you can delay the alarm). While the selected alarm is flashing, hold down Sleep/Snooze
and press the Time 4 or _ to adjust the snooze time (from 1 to 30 minutes) for that alarm. The
number of minutes and Sn appear on the display to confirm your selected snooze time. You can
set a different snooze time for each alarm.
To exit from alarm setup - To leave alarm setup mode, wait 10 seconds for it to disengage.
Or you can press AUX once or Alarm Setup a few times until there is no ALARM 1 or ALARM 2
flashing.
To check the alarm setting - To display the alarm setting for 10 seconds, press and release
Alarm Setup. Press again to display one alarm setup and repeat to display the other alarm setup.
Beading the alarm setup displays
Figure 13
Examp/es of a/arm setup
disp/ays
(9
VOLUME
ALARM I |_ "|_| D--| AM
OFF iD'Uu 2 S
ALARM 1 flashes. You can begin by setting the time.
ALARM, FM, ,--,2 ,_ PRESET
OFF STEREO | |_ _ • _ _
Pressing FM selects it as the source for ALARM 1.
®
r.n n AM VOLUMEALARMO Fn'U U 2 ='
ALARM 2 flashes. You can begin by setting the time.
OFF _|'_ |_l CD_" I
ALARM 2 |_|°|_| _ TRACK I
PressingCD selectsitas thesource for ALARM 2.
20