Open as PDF
Setting the time
To set the clock - Hold down either Time <1 or _ button or press the same one twice.
The time display changes slowly at first, then faster. Release the clock set button to stop.
Customizing the display
To set AM/PM (12 hour) or Military (24 hour) time - With the system off, hold
down Alarm Setup and press On/Off to switch between AM/PM (12 hour)and Military
(24 hour) time formats.
To select c|ock or source display mode - With the system on, hold down Alarm
Setup and press either Preset 1 to select clock display or Preset 2 to select source display.
• In clock display mode, the display shows the time while you are listening to the radio, CD,
In source display mode, the display shows informationabout the selected source (radio,
CD, or AUX).
In source display mode, press the Time 4 or _ to show the time momentarily.
To adjust the display brightness - The display dims automatically to medium or low
brightness, as appropriate for low light room conditions. You can adjust the brightness
setting of the display for both strong light and lowest light environments, but not for the
medium light setting. Turn the system off before setting brightness levels.
In a strongly lit room, hold down CD Mode _ and press Volume A or V to adjust the
setting between 5 and 9 (it is preset to 8).
In a barely lit room, hold down CD Mode _ and press Volume A or V to adjust the
setting between 1 and 5 (it is preset to 2).
If you do not want the system to dim automatically, set both levels to 5.
To turn off the display - With the system off, hold down CD Mode _ and press
On/Off to turn off the main display. The display only lights briefly when you press any
buttons and while the alarm is sounding. Repeat this step to turn the main display back on.
To check the volume setting when it is not displayed - With the system off or
on, hold down Alarm Setup and press Volume A or V to see the current volume setting.
To check the CD time or radio station frequency when it is not displayed -
With the system on, hold down Alarm Setup and press Track/Tune <_ or _ to see the CD
time or station frequency.
hold and press
To check the time when it is not displayed - With the system on or off, press the
Time _ or _. briefly to see the current time.