Filter
Top Products
E-3
ENGLISH
Power On/Off
Turning on the power
Press the
PWR
to turn on the unit.
Turning off the power
Press the
PWR
for more than 2 seconds.
Setting the Clock
The clock uses a 12-hour display system.
1. Turn the ignition key to the ON position.
2. Press the
PWR
to turn on the unit.
3. Press the
DISP
and hold 2 seconds to start.
Use the following buttons to set the clock. (The blinking
section can be adjusted.)
/ : Adjust the Hour and minute
: To activate Hour blink
: To activate Minute blink
4. Press the
DISP
to activate the clock.
Ignition-off Clock Call
The display will illuminate showing the time and then automati-
cally shut off after 5 seconds.
Briefly press the
DISP
while the ignition switch is in the “ OFF ”
position to activate.
Display Selector
Each time the
DISP
is pressed, the display window will change
as shown below;
• Radio mode
Frequency and Clock.
• CD mode
Elapsed track time and clock.
Volume Level Control
Press the
VOL
/
to adjust the volume level.
: Volume up
: Volume down.
You can check the volume level visually with the indicators in
the display window.
Muting the Sound
Briefly press
PWR
while the receiver is on.
While muting the sound, the MUTE indicator
on the display
is blinking.
To restore the previous volume level, press
PWR
again.
Loudness Effect
When listening to music at low volume levels, this feature will
boost the extremes of the bass and treble ranges to compen-
sate for the negative characteristics of human hearing.
Press the
LD/SENS
.
The “LD” indicator appears in the display window.
Pressing this button again will cancel this feature.
Adjusting the Sound Characteristics
1. Press the
AUD
to select the desired adjustment mode.
BASS ➜ TREBLE ➜ BALANCE & FADER ➜ Mute level
2. Press the following buttons to adjust the selected item. Make
the adjustment within 5 seconds after selecting. After 5
seconds, the display window will revert to previous indica-
tion.
Adjustment Range
BASS / BASS -7 BASS 7 /
TREBLE / TREB -7 TREB 7 /
BALANCE
L
9 (Full left)
R
9 (Full right)
FADER
F
9 (Full front)
R
9 (Full rear)
MUTE LEVEL (-80) (-0)
You can check the each level visually with the indicators in the
display window.
General Operations
Volume level meter
Center level mark
BALANCE
FADER
RPD540_p.1-9 (E) 9/9/99, 3:23 PM3