Filter
Top Products
19
FRANÇAIS ENGLISHESPAÑOL
PORTUGUÊSNEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
Naming an external audio
source
AUX NAME makes it possible to enter a
name of up to 8 characters for an external
audio source (AUX ON, see DSC Menu).
For this, press SRC to select the AUX mode
(only possible if AUX ON is set in the DSC
menu and CD changer is not connected).
• Press SRC as often as required until
AUX appears in the display.
Enter the AUX NAME in the DSC menu.
• Press DSC briefly.
• Press
/ to select the AUX NAME
function
• Press << >> to enter into editing
mode.
The adjustable position will flash.
• Press
/ to select the character you
want to enter. Select a dash “_” to
leave a blank space.
• Press << >> to select the next posi-
tion.
• When you have entered the name
completely, press DSC briefly to store
the name.
• Press DSC again to quit the DSC
menu.
Turn On Message (TOM)
This unit offers you the possibility to enter
a turn on message of up to 40 characters.
The message will briefly appear in the dis-
play each time you turn the unit on.
Proceed as follows:
Select the DSC mode.
• Press DSC.
• Press
/ to select TOM.
• Press << to turn the message off.
• Press >> two times to select the edit
mode.
• If there is no TOM programmed, dash-
es “_” will appear in the display.
• The cursor will flash at the current po-
sition. Press << / >> to move the cur-
sor.
• Press
/ to select a character. If
you want to enter a blank, select the
dash “_”.
• Press DSC to store the message.
Press DSC again to quit the DSC
mode.
If you want to change the message, select
TOM in the DSC mode and overwrite it in
the edit mode. If you want to change just a
few of the letters, press << / >> to move
the cursor to the corresponding position and
change that character only.