Filter
Top Products
14
Cassette deck operation
Cassette playback
Insert the tape into the slot with the open
side showing to the right. “CASSETTE” will
appear in the display. The tape will play in
the direction “TAPE 1”.
If a tape is already inside, press SRC to
select “CASSETTE” mode. The tape will
play in the direction last selected.
Reversing the tape direction
Press to change the tape direction dur-
ing cassette playback from TAPE1 to
TAPE2 or vice versa:
At the end of the tape, the unit will auto-
matically switch to the opposite side.
Skipping cassette tracks
CPS stands for Cassette Program Search
and allows you to skip over songs on the
tape.
The tracks must, however, be separately
by at least 3 seconds of blank tape.
During tape playback press either
or
on the rocker switch to activate the CPS
mode. “CPS FF” or “CPS FR” will appear
in the display. Press the button
/ repea-
tedly to skip the corresponding number of
tracks in either direction.
The number of tracks to be skipped will ap-
pear in the display and count down until the
Fast winding
Use the rocker switch to fast forward or re-
wind the tape during cassette operation:
>> forward
<< rewind
“FORWARD” or “REWIND” will light up in
the display.
Press the button indicating the opposite
direction,
, or / to stop the function.
If you have activated “Radio Monitor ON”,
the unit will play the radio station last se-
lected while the tape is winding. You can
alter the Radio Monitor setting in DSC
mode.
Tape type selection
If you are playing METAL or CrO
2
cassettes,
press MTL. “MTL” will then light up in dis-
play field 1.
DOLBY B NR (Noise reduction)*
Cassettes which have been recorded with
the DOLBY B NR system exhibit consider-
ably less tape noise and higher dynamics.
To play properly cassettes recorded using
this system, press
.
will light up in display field 3
track selected has been reached.
Press
or << >> to stop the function.
If you have activated “Radio Monitor ON”,
the unit will play the radio station last se-
lected while the tape is winding. You can
alter the Radio Monitor setting in DSC
mode.
Repeat song tracks
During tape playback press 4/RPT. “RPT”
will light up in display field 3; “REPEAT-T”
will appear briefly in display field 2. While
the tape is rewinding, “REWIND-T” will ap-
pear in the display. The track playing will
repeat until you press 4/RPT again. “RPT”
will disappear from the display.
Playback will now continue normally.
If you have activated “Radio Monitor ON”,
the unit will play the radio station last se-
lected while the tape is winding. You can
alter the Radio Monitor setting in DSC
mode.
SCAN
To scan all of the songs on a tape, press
SCA. “SCAN” will appear in the display.
All of the tracks on the tape in the tape deck
will be scanned briefly one after the other.
Press SCA again to switch the SCAN func-
tion off. The track currently playing will con-
tinue to play.