Black Box HS201A Headphones User Manual


 
13
CHAPTER 4: Headband
4. Headband
The 2-in-1 Headset can also be
equipped with a lightweight
flexible headband.
4.1 Installation
1. Remove the ear capsule.
2. With the corded side of the
receiver facing you, hold the
headset in your left hand
between your thumb and
index finger with the boom
pointing to the right.
3. With your right hand, hold
the headband so that the
C-ring opening is facing
towards the receiver (see
Figure 4-1).
Figure 4-1. Installing Headband.
4. Push the C-ring of the
headband onto the receiver
housing until it springs into
place in the groove.
5. Snap the large cushion onto
the speaker housing until it
clicks into place.
4.2 Removal
1. Remove the ear cushion.
2. In the left ear wearing style,
with the corded side of the
receiver facing you, hold the
headset in your left hand
between your thumb and
index finger with the boom
pointing to the left.
3. With your right hand, hold
the headband between your
thumb and index finger.
4. Pull up on the receiver and
push down on the
headband until the C-ring
snaps off of the receiver
housing (see Figure 4-2).
Figure 4-2. Removing Headband.
4.3 Changing Ears
To change to the other ear, rotate
the entire speaker housing under
the headband 180° (see Figure
4-3).