Filter
Top Products
STB & PVR Function
58
3-6.
Timer Conflict
The FV-L1 can record two programs simultaneously. If you attempt to
record more than two programs simultaneously, a timer conflict warning
message will be displayed. A timer conflict occurs in the following
situations;
A new timer overlaps with two existing timers at some point.
A timer begins while two recordings are already in progress.
A timer begins while a recording is already in progress on the same
service.
NOTE
When you set a new timer, the FV-L1 will only check for conflicts with
existing timers. It will not check if the new timer conflicts with
recordings started by the instant recording method, and will only do
this check when the timer is ready to begin.
1) New Timer Overlaps Two Existing Timers
You cannot add a new timer to record three programs at the same time.
If you attempt to do so, a timer conflict dialog is displayed to show the
conflicting timers, as shown below.
In order to add the new timer, you must delete one group of timers
displayed in the list. Use the
LEFT/RIGHT
buttons to select a group of
timers and press
OK
to delete that group. If you decide not to proceed,
press
EXIT,
and the new timer will be cancelled.
NOTE
You may find that re-organising your existing timers to remove
overlaps where possible will solve many timer conflict problems.