Beyonwiz FV-L1 Home Theater System User Manual


 
Quick Setup
26
2) Audio Outputs
The FV-L1 supports 5.1ch audio via the RCA connectors on the rear of
the unit and will decode and output Dolby Digital via a built in decoder.
It also supports digital outputs with optical and coaxial ports.
Audio Format: Select one of the following options to suit your chosen
audio connection in the “Audio Connection” section in Chapter 3;
2ch for stereo speaker connections.
5.1ch for 5.1 speaker connections.
passthrough – to use an external audio decoder (e.g. amplifier).
S/PDIF Output: Select “Enable” if using the digital audio output
through the coaxial and optical ports.
Dolby D Compression: Select either of the following options;
Line Mode – recommended for most users.
RF Mode recommended for when audio is connected directly to
the TV using RF cables.
NOTE
If you set the audio format to 2ch, the FV-L1 mixes down 5.1ch audio
source to 2ch audio.
If the content of a channel broadcasted has 2ch audio source, the FV-
L1 cannot expand the 2ch audio source to 5.1ch audio format.
Therefore, you will only hear sound from the front speakers even
though you have connected a 5.1ch speaker system and set the FV-
L1 as 5.1ch audio.
3) Colour Setting
You can adjust the colour output of the FV-L1.
The three options are brightness, contrast and saturation. Use the
UP/DOWN
buttons to select each option, and adjust the setting with
the
LEFT/RIGHT
buttons. You can restore all colour settings to the
factory default values by pressing the
RED
button. To apply your
chosen settings, use the
UP/DOWN
buttons to select “Accept” and
press
OK
. To cancel the new settings, select “Cancel” and press
OK
, or
press the
EXIT
button.