Beyonwiz FV-L1 Home Theater System User Manual


 
Troubleshooting Guide
104
strength and/or quality is adequate. If not,
please contact an authorised antenna service
agent or licensed contractor to seek advice
concerning improving your TV reception.
No sound, or poor
sound
Check the Volume controls of the product, TV
and other audio device/s.
Check the Mute status of the product, TV and
other audio device/s.
Check that the audio output connections on the
product have been connected to the correct
input connectors on the TV and/or other audio
device/s.
Check that the product’s audio output settings
configured in the Setup menu are correct.
(Setup\Configuration\A/V Output)
Remote control
does not operate
the FV-L1
To use the product with the supplied Remote
control, the Remote control's infrared sender
should be pointed direc
tly towards the
products infrared receiver.
Check the remote controls batteries.
Ensure that the correct mode is selected on the
Remote control i.e.
STB
mode if operating FV-
L1 or
TV
mode if operating the TV.
If the Remote control range seems to be
limited, check to ensure that the protective
plastic film (for shipping protection) on the
front panel of the FV-L1 has been removed.
Remote control
does not operate
TV
To use the equipment with Remote control, the
Remote control's infrared sender should be
pointed directly towards the TV's Remote
control receiver.
Check the battery of the Remote control.
Ensure that the correct mode is selected on the
remote control i.e.
STB
mode if operating the
FV-L1 or
TV
mode if operating the TV.
Has the Remote control been correctly
programmed to operate your TV?
(See page 7 of this Guide)
Timers are not
recording
Check to ensure that the timers have been set
correctly.
Check whether more than two timers overlap.
Check whether the
power supply to the
product has been disconnected.
I can’t connect to
my network via
LAN
Check to ensure that the Ethernet (LAN) cable
is connected to the correct port on the rear of
the product.
Is the correct type of Ethernet cable being
used for your network connection?
(i.e. a “straight-through” or “crossover” cable?)
Have the LAN settings been correctly
configured in the product’s Setup Menu?
(Setup\Network\Setting)