Filter
Top Products
MCS-D 200 Control Unit
E
35
Go to the “Booth” line and enter the booth number. Then use the down navigator button to go to the “Device ID” line. Use
the right or left hand navigator button to enter the first interpreter station ID number.
Then press the MIC button of the first interpreter station to assign the first ID number to this microphone station. The LED ring
will illuminate and the ID number will be shown on the display of the microphone station.
Then press the microphone button of the second interpreter station. Then press the microphone button of the second interpreter
station. The LED ring will illuminate and the next ID number is shown on the display of the interpreter station and on the
MCS-D 200 control unit. Proceed with the next interpreter station as described above and so on.
Assign the ID numbers to all interpreter stations in the same booth.
To assign the ID numbers to the second booth go to the “Booth” line and enter the second booth number. Assign the ID
numbers to the interpreter stations as described above.
You may assign the same device ID numbers if the interpreter stations are in different booths.
For example:
Booth 0001: Interpreter station no. 0001, 0002;
Booth 0002: Interpreter station no. 0001, 0002.
Refer to the previous chapter to find out how individual ID numbers are assigned.
3.3.8.3 Conflicts
A device identification number should be assigned to each interpreter station to identify them easily. Please make sure that
each ID number is only assigned once within the same session to avoid conflicts.
3.3.9 Technician IDs
To enter an ID for the MCS-D 2074 service microphone station proceed as described in chapter 3.3.7 “Delegate IDs”.
press the ENTER button
Use the up or down navigator button for
scrolling
press the ENTER button