Filter
Top Products
page 6© 2007 bel canto design, Ltd. CD-2 User’s Guide 0607revA
DO NOT ATTEMPT to OPERATE the
CD-2 WITHOUT a CD in PLACE
If you attempt to take the CD-2 out of
standby when no CD is present it will go
back into standby. The CD Laser is inac-
tive whenever the CD-2 is in Stop or
Standby mode. The Laser will not oper-
ate without a CD and the Magnetic Puck
on the turntable. You can ONLY take the
CD-2 output of Standby with a CD in
place on the unit and the Magnetic Puck
on the CD.
NEVER REMOVE the CD-2 MAG-
NETIC PUCK while the CD is SPIN-
NING
NEVER PRESS DOWN on the CD-2
turntable as this will damage the
turntable mechanism.
NEVER DROP the MAGNETIC
PUCK or ANY OTHER OBJECT on
the TURNTABLE
NEVER PACK or SHIP the CD-2
with the MAGNETIC PUCK on the
TURNTABLE
Undo pressure or shock to the turntable
will damage the mechanism. Repair of
the mechanism for this damage is not
covered under the CD-2 warranty.
Also, NEVER TOUCH the LENS of
the CD MECHANISM or clean it with
anything other than specific cloth
designed for cleaning Optical Disc play-
er lenses. You can use a small puff of
clean air to remove minor dust buildup
or just play a CD and the motion of the
CD should keep the lens clear of dust. If
you are concerned about dust buildup in
your environment you can leave a blank
CD in place to cover the mechanism
when not using the CD-2.
REPAIR of the CD-2 MECHANISM
DUE to MISHANDLING is NOT
COVERED by the CD-2 WARRANTY
Following these guidelines will result in
many years of reliable operation. The
CD-2 mechanism is a professional grade
device and is inherently a high reliability
device.
Note that there are no user serv-
iceable parts inside the CD-2
chassis.
Opening the chassis will void the war-
ranty.
There are no fuses inside the CD-
2.
Use only with the supplied power sup-
ply. Use with a different supply will void
the warranty.
If you have a problem with the opera-
tion of your CD-2 contact Bel Canto
Design or your dealer/distributor for
service.
CD-2 Care and Warnings