Filter
Top Products
11
ULTRALINK UL2000M
are shown in the display again.
Deactivating LOCK
1. Press the SET button. LOC ON is shown in the display.
2. Press the UP or DOWN button once to select LOCOFF.
3. Press the SET button confirm, hence deactivating the keylock function. The procedure is now over,
and the basic settings are shown in the display again.
2.2.7 PRESET
The ULR2000 lets you work with 4 presets, each with 8 channels.
Factory presets (Presets 2, 3 and 4)
In the ULR2000, there are 3 factory presets (each with 8 interference-free channels). That means that all 8
channels of one preset can run simultaneously with 8 different transmitters and receivers without causing
mutual interference.
The channels in the 3 factory presets are all assigned to different frequencies. This way, you can always
select a frequency range that assures the best signal transmission.
The following table shows which frequencies are stored in the factory presets.
CHANNEL PRESET 2 PRESET 3 PRESET 4
1 798,700 MHz 798,400 MHz 798,100 MHz
2 799,950 MHz 798,950 MHz 798,650 MHz
3 800,650 MHz 799,800 MHz 799,500 MHz
4 801,050 MHz 801,450 MHz 801,150 MHz
5 802,850 MHz 803,250 MHz 802,950 MHz
6 804,500 MHz 803,650 MHz 803,350 MHz
7 805,350 MHz 804,350 MHz 804,050 MHz
8 805,900 MHz 805,600 MHz 805,300 MHz
Table 2.1: Factory preset frequencies (presets 2,3 and 4)
User preset (Preset 1)
Preset 1 is meant for the user. Frequencies of your own choice can be stored in the 8 storage slots of this
preset.
If you have not stored any of your own frequencies, the frequencies stored in the user preset (Preset 1) are
identical to the frequencies stored in Preset 3.
Loading a preset
1. Press the SET button to get to the menu.
2. Press the DOWN button once to get to PRESET.
3. Press the SET button again to get to the PRESET submenu. The display shows the currently active
preset.
4. Press the UP and DOWN buttons to select the desired preset. The display shows PSET 1 (2, 3 or 4).
5. Press the SET button to load up the preset you selected. The procedure is now over, and the basic
setting is shown in the display again.
2. ULR2000 RECEIVER