Filter
Top Products
Record a programme
You can make the hard disc recorder
record an available source or
programme at any time you specify.
The hard disc recorder starts and
stops the recording automatically.
You can make a Timer – a timed
recording – which takes place once,
or on certain days of the week. Enter
as many as 15 Timers at one time.
Your stored Timers are listed in the
TIMER INDEX. Here, you can edit or
delete your Timers.
You can also record the current
programme here and now.
To ensure that your Timers are executed
correctly, set the built-in clock to the
correct time and date. For further
information about the clock, refer to
the chapter ‘Preference settings’ on
page 38.
Set a Timer in the TIMER PROGRAMMING
menu. Here, you select the source to be
recorded, the programme’s start time, the
stop time and the date or days of the week
that the programme is shown.
Program a Timer …
> Press V MEM* and then the green button
to
bring up the hard disc recorder’s main menu
> Press
to highlight TIMER PROGRAMMING.
> Press GO to bring up the menu for setting
a timed recording. SOURCE is highlighted.
> Press
or to step from option to option.
> Use the number buttons or
or to enter
information for your timed recording; source,
program number, stop time, date, and so on.
To program a daily or weekly Timer, highlight DATE
and press the green button. DATE changes to
WEEKDAYS.
> Press EXIT to leave the menu, or …
> Press GO to store the recording.
Note that you cannot record programs
copy-protected by Macrovision.
The TIMER PROGRAMMING menu contains
additional options when you set the FEATURE
LEVEL to ADVANCED. For further information
about the content of the TIMER PROGRAMMING
menu, refer to the chapter ‘On-screen menus’ on
page 44.
Timer recording
TIMER PROGRAMMING
GO
SOURCE V.TUNER
PROGRAM 1
START TIME 14:41
STOP TIME 15:41
DATE THU 26 JUN
PROTECTION OFF
store
10
*NOTE! On some Beo4 remote controls, the V MEM
button is called V TAPE.