Auralex Acoustics SFS-112 Stereo System User Manual


 
SonoFlat Panel Installation Guide
Apply Tubetak Pro to the back of the SonoFlat
Panel, as pictured.
Carefully press SonoFlat Panel to the marked
location of the wall or ceiling. Maintain continuous
pressure. Depending on environmental and
surface conditions, it will take anywhere from
2-4 minutes to hold.
Mark intended location of each SonoFlat
Panel on the wall or ceiling.
SonoColumn Installation Guide Continued
Place SonoCollar around SonoColumn, if
desired. The inside section of each SonoCollar
can also be used to increase the height of the
SonoColumn by 6”.
Carefully press SonoColumn to the marked
location of the wall or ceiling. Maintain continuous
pressure. Depending on environmental and
surface conditions, it will take anywhere from
2-4 minutes to hold.
TIP
For a stronger hold, with the adhesive applied, press
SonoColumn firmly into place, immediately remove it and
press it firmly again into the same spot.
Or
TIP
You can use T-Pins to temporarily hold the panel in place
while the adhesive sets.