Filter
Top Products
9
Disc error
If a damaged disc or a support that cannot be read or anytime a CD is not loaded in proper position, the unit’s CD tray will open and
the display will show “DISC ERROR”. In this case just remove the CD and replace with a new one or put the same one in the proper
position.
Disc error
Nel caso venga inserito un disco molto danneggiato o un supporto non riconoscibile o qualora il CD venga inserito non
correttamente nel cassetto, l’apparecchio apre il cassetto e visualizza sul display la scritta “DISC ERROR”. In tal caso rimuovere la
causa dell’errore (inserire correttamente il CD, o sostituirlo con uno riconoscibile o non danneggiato).
Specifications
Parameters Measurement conditions Values
Number of channels - 2
Maximum output tension 0DBFS 5.3Vpp (1.9VRMS)
Frequency response +0/-3dB 20Hz-20kHz
Noise level Band limits 0Hz-20kHz -120dB
Signal/noise ratio 20Hz-20kHz -95dB
Supply - 230V 50-60Hz or 115V 50-60Hz
Power consumption - 40VA
Specifiche Tecniche
Parametro Condizioni di misura Valore
Numero di canali: - 2
Tensione max di uscita 0DBFS 5.3Vpp (1.9VRMS)
Risposta in frequenza +0/-3dB 20Hz-20kHz
Livello di rumore Limiti di banda 0Hz-20kHz -120dB
Rapporto segnale/rumore 20Hz-20kHz -95dB
Alimentazione: - 230V 50-60Hz oppure 115V 50-60Hz
Assorbimento: - 40VA
Troubleshooting
Symptom Cause Remedy
The unit is in stand by Deactivate the standby mode by pressing
the button STANDBY on the
front panel or STBY on the remote
Power cord is not correctly connected Check that the plug of the cable is inserted
to the net Correctly
Display off
No sound
No response to commands
Burnt fuse inside the Unit Contact your Audio Analogue retailer in
order to replace the fuse
Interconnect Cables between Primo CD
VT and amplifier are not connected
correctly or are faulty
Check the cable status and the correct
connection
Display on
No sound
Source selected not correctly on the
amplifier
Check that Primo CD is well selected with
the amplifier input selector
The CD plays but Display is off
Display is not connected correctly or faulty
Contact Audio Analogue retailer to verify
the connections and eventual replacement
of the board
Batteries are down or missing Insert or replace the batteries (2 AAA type)
The remote does not work
Front panel of the appliance is too far or
the angle is not right
Get nearer the appliance or change angle
If the remedies that have been suggested do not work or the problem is not in the above list, contact your Audio Analogue
retailer.
Ricerca guasti
Sintomo Causa Rimedio
Display spento
Nessun suono
Nessuna risposta ai comandi
L’apparecchio è in stand by Togliere l’apparecchio dallo stato di stand
by premendo il tasto STANDBY sul
pannello frontale oppure STBY sul
telecomando