Audio Analogue SRL STEREO LINE PREAMPLIFIER Stereo Amplifier User Manual


 
15
Set-up navigation
Due to the reduced size of the display, only one option at a time is shown. Use the remote controller to navigate through
the different options, to choose the desired one and also to modify the parameters value. To select the desired option,
repeatedly press the “SET UP” button on the front panel or the “SET” button on the remote controller. It is possible to
modify the parameters of the selected option by rotating the left selector on the front panel or pressing the “IN+/IN-“
buttons on the remote controller. To exit set-up, choose the “EXIT” option and press the “SET” button. To exit set-up,
press the button since when the preamplifier functioning status is shown on the display.
Set-up options
Mono: this option activates/deactivates the mono out that could be connected to a sub-woofer speaker.
By-Pass: this option allows choosing which of the 8 ins to use for sending the signal to the outs bypassing the
preamplifier when it is in stand-by mode.
Balance: this option allows modifying the channels relative levels.
Navigazione del set-up
A causa dello spazio limitato, sul display del pannello frontale compare una sola voce di menu per volta. Per questo
motivo, e anche per scorrere le varie voci e selezionare quella desiderata, nonché per modificare i valori dei parametri
visualizzati, è possibile navigare il setup sia dal pannello frontale che dal telecomando. Per selezionare la voce
desiderata bisogna premere più volte il tasto “SET UP” del pannello frontale oppure “SET” del telecomando. E’ possibile
modificare i parametri relativi alla voce selezionata ruotando il selettore a sinistra sul pannello frontale, oppure premendo
i tasti “IN+/IN-“ del telecomando. Per uscire dal set-up è sufficiente premere il tasto sino a quando sul display non verrà
visualizzato nuovamente lo stato di funzionamento del preamplificatore.
Opzioni di set-up
Mono: è possibile attivare o disattivare l’uscita mono, che può essere collegata ad un diffusore sub-woofer
By-Pass: attivando questa opzione, si può selezionare uno degli otto ingressi per inviare il segnale alle uscite,
bypassando il preamplificatore, quando quest’ultimo è in stand by.
Balance: questa opzione consente di modificare i livelli relativi dei due canali rispetto al livello generale di
ascolto.