Filter
Top Products
Power led off and no sound
Power cord incorrectly inserted and/or amplifier switched off
Check that cord is inserted both in the amplifier’s mains socket and in
the wall AC outlet and that the switch is in the “ON” position
Mains fuses burnt out
Check the fuses in the fuse holders (unplug cord from mains first!) next
to the special 16 Amp socket and eventually replace with same type
Power led red and no sound
Amplifier in standby
Press standby button to exit the standby mode
Power led green and no sound
Mute activated
Press mute button on the remote to deactivate mute
Volume knob turned completely anticlockwise
Turn volume knob clockwise
Source not propectly selected
Choose the correct option with the source selector
Source not connected or off or faulty signal cables
Check source and cables
Speaker cables not correctly connected or faulty
Check and connect speaker cable properly
Recording is not possible
Source not properly selected
Choose the correct option with the record selector
Source not connected or off or faulty signal cables
Check source and cables
Power led flashing red and no sound (Speaker protection circuit active)
Short-circuits on speaker connections
Check and connect speaker cables properly
Severe power amp overload
Lower the listening volume or check for speaker integrity
If the above suggestions don’t work, or if your problem isn’t listed above,
please contact your Audio Analogue dealer
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
CAUSE
REMEDY
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
16