Filter
Top Products
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
11
Power leds off and no sound
Power cord incorrectly inserted and/or amplifier switched off
Check that cord is inserted both in the amplifier mains socket and in
the wall AC outlet and that the switch is in the “on” position
Main fuses burnt out
Check the fuses in the fuse holder (unplug cord from mains first!!) next
to the special socket and eventually replace with same type
Trigger-driven power-on not possible
The trigger cord is defective
Please replace with another cord
Trigger selector switched to “off” position
Switch the selector to “on” position
The preamplifier trigger output is defective or switched off
Check for 12V on preamplifier trigger output
Power leds red and no sound
Amplifier in stand by
Provide a signal at an adequate volume
One or more leds blinking red and no sound (speakers protection circuit
active)
Short-circuits on speakers connections
Turn off the unit, check and connect speakers cables properly and turn
on the unit again
Severe power amp overload
Turn off the unit, lower the listening volume of your preamplifier or check
for damage to speakers. Then turn on the unit again.
If the suggestions do not work, or your problem is not in the Iist,
please contact your Audio Analogue dealer