Filter
Top Products
15
Troubleshooting
Symptom Cause Remedy
Power cord incorrectly plugged
Make sure the power cord is correctly
plugged into the wall outlet
No led on
No sound
Burned-out fuses
Check fuses in the fuse panel (after
unplugging the power cord from the wall
outlet) above the IEC inlet and replace
them with new ones of the same type
Low volume Turn volume knob right
Faulty or incorrectly plugged signal
connectors between Puccini Settanta and
the sources
Check cords and their connection
Off or incorrectly selected source
Check if the source is on and active and if
it is correctly selected using the in selector
Only one in led is on
No sound
Faulty or incorrectly plugged power cords
between Puccini Settanta and the
speakers
Check cords and their connection
Selected in leds are on, volume control
works but the leds are off, or selected in
leds are off and volume leds are on
Faulty or incorrectly plugged front panel
Contact your Audio Analogue retailer for
connections check and front panel
substitution
Recording is impossible Incorrectly selected source
Select the right source using the recording
selector
No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries)
Remote controller doesn’t work
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.