Filter
Top Products
11
Specifiche Tecniche
Parametro Condizioni di misura Valore
Numero di canali: - 2
Guadagno stadio linea 20Hz-20kHz 12dB
Risposta in frequenza Attenuazione –0dB
Attenuazione –20dB
Attenuazione –40dB
15Hz – 100kHz +0/-3dB
15Hz – 100kHz +0/-3dB
15Hz – 150kHz +0/-3dB
Livello di rumore Attenuazione 0dB,
Limiti di banda 0Hz-48kHz,
ingressi chiusi su 20 Ohm
-102.5dB sotto 1Vrms in uscita
-130dB sotto la tensione massima nominale
Rapporto segnale/rumore 22Hz-22kHz 86dB
Separazione: R->L, L->R, 10Vrms @ 1kHz sul canale
interferente, ingresso del canale misurato
chiuso su 20 Ohm, 20Hz-20.000Hz
>90dB
Alimentazione: - 230V 50-60Hz oppure 115V 50-60Hz
Assorbimento: - 260VA
TROUBLESHOOTING
Symptom Cause Remedy
Power cord incorrectly plugged Make sure the power cord is correctly
plugged into the wall outlet
No led on
No sound
Burned-out fuses Check fuses in the fuse panel (after
unplugging the power cord from the wall
outlet) above the IEC inlet and replace
them with new ones of the same type
Low volume Turn volume knob right
Faulty or incorrectly plugged signal
connectors between Verdi Settanta and
the sources
Check cords and their connection
Off or incorrectly selected source Check if the source is on and active and if
it is correctly selected using the in selector
Only one input led is on
No sound
Faulty or incorrectly plugged power cords
between Verdi Settanta and the speakers
Check cords and their connection
Selected in leds are on, volume control
works but the leds are off, or selected in
leds are off and volume leds are on
Faulty or incorrectly plugged front panel Contact your Audio Analogue retailer for
connections check and front panel
substitution
Recording is impossible Incorrectly selected source Select the right source using the recording
selector
Remote controller doesn’t work No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries)
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
Selected in leds are on, volume control
works but the leds are off, or selected in
leds are off and volume leds are on
Faulty or incorrectly plugged front panel Contact your Audio Analogue retailer for
connections check and front panel
substitution
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.