Filter
Top Products
13
TROUBLESHOOTING
Symptom Cause Remedy
Incorrectly plugged power cord Make sure the power cord is correctly
plugged into the wall outlet
No leds on
No sound
Burned-out fuses Contact your Audio Analogue retailer
for fuse check and substitution
Low volume Increase volume
Faulty or incorrectly plugged signal
connectors between Primo Cento VT
and the sources
Check cords and their connection
Off or incorrectly selected source Check if the source is on and active
and if the correct in is selected
One led in on
No sound
Faulty or incorrectly plugged power
connectors between Primo Cento VT
and the speakers
Check cords and their connection
In leds are on, volume control working
but volume leds are off or in leds are
off but volume leds are on
Faulty or incorrectly plugged front
panel
Contact your Audio Analogue retailer
for connections check and front panel
substitution
Remote controller doesn’t work Incorrectly selected source Select the right source using the in
selector
No battery/ worn-out battery Place/replace battery (2 ‘AAA’
batteries)
You’re standing too far or on an
exceeding angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your
local Audio Analogue retailer.