Audio Analogue SRL AUDIO ANALOGUE INTEGRATED AMPLIFIER Stereo Amplifier User Manual


 
2
INTRODUCTION
AUDIO ANALOGUE does not take any responsibilities in the following cases:
Whenever the operational procedures related to the use and the maintenance of the equipment, as described in this manual, are not
respected.
Whenever damages to the equipment occur because of fixing or modifications made from non-authorized staff or because of normal
deterioration of the system.
No part of this manual can be reproduced by any means, transmitted or copied for private or public use without private authorization
from AUDIO ANALOGUE.
The information contained in this manual is related to the data kept by AUDIO ANALOGUE at the moment of the issue of this
publication; AUDIO ANALOGUE has the right to make changes to this document without notice.
The equipment has been designed and manufactured according to the Regulations of the Community 89/336/CEE and is marked CE.
This equipment can’t be used for different purposes other than those for which it has been manufactured.
AUDIO ANALOGUE does not take any responsibilities for accidents or damages due to improper use of the equipment.
WARNING
Please do respect the safety standards contained in this manual before starting to operate the equipment.
Do not open the equipment. No further interventions than those described in this manual should be made. For technical assistance,
please contact a qualified technician or an AUDIO ANALOGUE dealer.
Not respecting the instructions contained in this manual will invalidate the guarantee terms and conditions.
NECESSARY PRECAUTIONS FOR SAFETY AND MAINTENANCE
ATTENTION: Read the following instructions and precaution carefully and completely before.operating or manteining your Audio
Analogue Maestro Class A integrated amplifier.
It’s mandatory
to comply with the following regulations to avoid any hazard:
Always disconnect your entire system from AC mains before connecting or disconnecting any cables.
The labels containing information about safety must be always visible and in good conditions.
Never block air flow through ventilation slots or heatsink to avoid excessive overheating.
The equipment should be kept to a minimal distance of 15 cm from any object and should not be placed on carpet or other soft
surfaces.
Do not switch on the equipment until it has not been correctly and completely installed.
Always supply the equipment with the proper voltage as stated on the rear label. If in doubts about the available supply, please
contact a qualified technician or an AUDIO ANALOGUE dealer.
This equipment must be terminated with a three-conductor AC mains power cord which includes an earth ground connection. To
prevent shock hazard, all three connections must always be used.
In case of damages occurred to the supply cable, it should be immediately replaced with an other of the same kind.
Do not place any objects over the supply cable. The cable shouldn’t be knotted, pinched or abruptly bended.
Replace the fuses always with others of the same kind.
Do not use the equipment close to water or other liquids. If any liquid fill in the equipment, the mains plug must be disconnected from
the socket avoiding to touch any metal parts. The equipment must be checked by qualified technician before being operated again.
Do not place recipients containing liquids on the equipment, even if it is switched off.
Keep the equipment far away from sources of heat such as the solar light, ovens, radiators etc…
Always unplug the supply cable during lightning storms.
Always switch off and unplug the mains cable before cleaning the equipment externally
: this operation should be made only using a
dry and soft cloth. Never use alcohol based cleaning material.
Internal condesation can be formed if the amplifier is carried from an extremely cold environment to an extremely hot one. Please wait
at least for an hour before operating it again.
Please unplug the equipment if not used for long periods.
INSTRUCTIONS TO PUT IT OUT OF SERVICE
Consult qualified staff.
Follow the regulations of the current legislation regarding recycling and waste disposal.